The VCC and VCCA supplies of the DSI<->eDP bridge are derived from
vreg_l2a_1p2 and controlled by a GPIO on the PMIC. Add the regulator
here so Linux can control it.
Signed-off-by: Caleb Connolly <caleb.connolly@xxxxxxxxxx>
---
.../boot/dts/qcom/sdm850-lenovo-yoga-c630.dts | 30 ++++++++++++++++++++++
1 file changed, 30 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sdm850-lenovo-yoga-c630.dts b/arch/arm64/boot/dts/qcom/sdm850-lenovo-yoga-c630.dts
index 22a7d997cdb0..94e37e5d2177 100644
--- a/arch/arm64/boot/dts/qcom/sdm850-lenovo-yoga-c630.dts
+++ b/arch/arm64/boot/dts/qcom/sdm850-lenovo-yoga-c630.dts
@@ -80,6 +80,22 @@ adsp_mem: memory@8c600000 {
};
};
+ sw_edp_1p2: edp-1p2-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "sw_edp_1p2";
+
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&sw_edp_1p2_en>;
+
+ gpio = <&pm8998_gpios 9 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+
+ vin-supply = <&vreg_l2a_1p2>;
+ };
+
sn65dsi86_refclk: sn65dsi86-refclk {
compatible = "fixed-clock";
#clock-cells = <0>;
@@ -425,6 +441,8 @@ sn65dsi86: bridge@2c {
enable-gpios = <&tlmm 96 GPIO_ACTIVE_HIGH>;
+ vcca-supply = <&sw_edp_1p2>;
+ vcc-supply = <&sw_edp_1p2>;
vpll-supply = <&vreg_l14a_1p88>;
vccio-supply = <&vreg_l14a_1p88>;
@@ -500,6 +518,18 @@ &mss_pil {
firmware-name = "qcom/sdm850/LENOVO/81JL/qcdsp1v2850.mbn", "qcom/sdm850/LENOVO/81JL/qcdsp2850.mbn";
};
+&pm8998_gpios {
+ /* This pin is pulled down by a fixed resistor */
+ sw_edp_1p2_en: pm8998-gpio9-state {
+ pinconf {
+ pins = "gpio9";
+ function = "normal";
+ bias-disable;
+ qcom,drive-strength = <0>;
+ };
+ };
+};
+
&qup_i2c10_default {
drive-strength = <2>;
bias-disable;
--
2.41.0
