Re: [PATCH v3 05/13] dt-bindings: remoteproc: glink-rpm-edge: Use "glink-edge" as node name

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 15/06/2023 18:50, Stephan Gerhold wrote:
> Semantically glink-edge and glink-rpm-edge are similar: Both describe
> the communication channels to a remote processor. The RPM glink-edge is
> a special case that needs slightly different properties but otherwise
> it is used exactly the same.
> 
> To improve consistency use the same "glink-edge" node name also for
> glink-rpm-edge. Drop the $nodename from qcom,glink-edge.yaml to avoid
> matching the wrong schema. qcom,glink-edge.yaml is always referenced
> explicitly from other schemas. This will already ensure that the nodes
> are being checked, so it's not necessary to bind to all nodes named
> "glink-edge".
> 
> Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx>


Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

Best regards,
Krzysztof




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux