On 2023-06-09 15:57:16, Jessica Zhang wrote:
> Add a DPU INTF op to set the DCE_DATA_COMPRESS bit to enable the
> DCE/DSC 1.2 datapath
>
> Note: For now, this op is called for command mode encoders only. Changes to
> set DATA_COMPRESS for video mode encoders will be posted along with DSC
> v1.2 support for DP.
>
> Signed-off-by: Jessica Zhang <quic_jesszhan@xxxxxxxxxxx>
> ---
> drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c | 3 +++
> drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 13 +++++++++++++
> drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h | 3 +++
> 3 files changed, 19 insertions(+)
>
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> index 63ba0082b6ee..b856c6286c85 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> @@ -67,6 +67,9 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
> phys_enc->hw_intf->ops.bind_pingpong_blk(
> phys_enc->hw_intf,
> phys_enc->hw_pp->idx);
> +
> + if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression)
> + phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf);
It was probably not necessary to drop this after adding dsc!=0:
Reviewed-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
> }
>
> static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> index 530f82e34c1e..5b0f6627e29b 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> @@ -91,6 +91,7 @@
>
> #define INTF_CFG2_DATABUS_WIDEN BIT(0)
> #define INTF_CFG2_DATA_HCTL_EN BIT(4)
> +#define INTF_CFG2_DCE_DATA_COMPRESS BIT(12)
>
>
> static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
> @@ -512,6 +513,15 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf,
>
> }
>
> +static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx)
> +{
> + u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2);
> +
> + intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
> +
> + DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2);
> +}
> +
> static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
> unsigned long cap)
> {
> @@ -532,6 +542,9 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
> ops->vsync_sel = dpu_hw_intf_vsync_sel;
> ops->disable_autorefresh = dpu_hw_intf_disable_autorefresh;
> }
> +
> + if (cap & BIT(DPU_INTF_DATA_COMPRESS))
> + ops->enable_compression = dpu_hw_intf_enable_compression;
> }
>
> struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg,
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
> index 33895eca1211..99e21c4137f9 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
> @@ -70,6 +70,7 @@ struct intf_status {
> * @get_autorefresh: Retrieve autorefresh config from hardware
> * Return: 0 on success, -ETIMEDOUT on timeout
> * @vsync_sel: Select vsync signal for tear-effect configuration
> + * @enable_compression: Enable data compression
> */
> struct dpu_hw_intf_ops {
> void (*setup_timing_gen)(struct dpu_hw_intf *intf,
> @@ -106,6 +107,8 @@ struct dpu_hw_intf_ops {
> * Disable autorefresh if enabled
> */
> void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
> +
> + void (*enable_compression)(struct dpu_hw_intf *intf);
> };
>
> struct dpu_hw_intf {
>
> --
> 2.40.1
>
