On 31/05/2023 21:01, Krzysztof Kozlowski wrote:
On 25/05/2023 14:29, Srinivas Kandagatla wrote:
Add support for the lpass clock controller found on SC8280XP based devices.
This would allow lpass peripheral loader drivers to control the clocks and
bring the subsystems out of reset.
Currently this patch only supports resets as the Q6DSP is in control of
LPASS IP which manages most of the clocks via Q6PRM service on GPR rpmsg
channel.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
drivers/clk/qcom/Kconfig | 8 ++++
drivers/clk/qcom/Makefile | 1 +
drivers/clk/qcom/lpasscc-sc8280xp.c | 63 +++++++++++++++++++++++++++++
3 files changed, 72 insertions(+)
create mode 100644 drivers/clk/qcom/lpasscc-sc8280xp.c
diff --git a/drivers/clk/qcom/Kconfig b/drivers/clk/qcom/Kconfig
index 85869e7a9f16..e25993abb519 100644
--- a/drivers/clk/qcom/Kconfig
+++ b/drivers/clk/qcom/Kconfig
@@ -523,6 +523,14 @@ config SC_LPASSCC_7280
Say Y if you want to use the LPASS branch clocks of the LPASS clock
controller to reset the LPASS subsystem.
+config SC_LPASSCC_8280XP
+ tristate "SC8280 Low Power Audio Subsystem (LPASS) Clock Controller"
depends on ARM64 || COMPILE_TEST
Thanks, Will do that in v3.
--srini
Best regards,
Krzysztof
