While exiting deep sleep, serial port loses its configuration
hence it prints garbage characters on console.
Set serial port configuration while resume from deep sleep.
Signed-off-by: Mehul Raninga <quic_mraninga@xxxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 8582479f0211..c04b8fec30ba 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -20,6 +20,7 @@
#include <linux/serial.h>
#include <linux/serial_core.h>
#include <linux/slab.h>
+#include <linux/suspend.h>
#include <linux/tty.h>
#include <linux/tty_flip.h>
#include <dt-bindings/interconnect/qcom,icc.h>
@@ -1737,6 +1738,8 @@ static int qcom_geni_serial_sys_resume(struct device *dev)
if (uart_console(uport)) {
geni_icc_set_tag(&port->se, QCOM_ICC_TAG_ALWAYS);
geni_icc_set_bw(&port->se);
+ if (pm_suspend_via_firmware())
+ qcom_geni_serial_port_setup(uport);
}
return ret;
}
--
2.17.1
