Re: [PATCH 2/2] arm64: dts: qcom: ipq9574: add support for RDP454 variant

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 5/19/2023 11:01 PM, Konrad Dybcio wrote:

On 19.05.2023 12:31, Poovendhan Selvaraj wrote:
From: POOVENDHAN SELVARAJ <quic_poovendh@xxxxxxxxxxx>

Add the initial device tree support for the Reference Design Platform (RDP)
454 based on IPQ9574 family of SoCs. This patch adds support for Console
UART, SPI NOR and SMPA1 regulator node.

Signed-off-by: Poovendhan Selvaraj <quic_poovendh@xxxxxxxxxxx>
---
  arch/arm64/boot/dts/qcom/Makefile           |  1 +
  arch/arm64/boot/dts/qcom/ipq9574-rdp454.dts | 92 +++++++++++++++++++++
  2 files changed, 93 insertions(+)
  create mode 100644 arch/arm64/boot/dts/qcom/ipq9574-rdp454.dts

diff --git a/arch/arm64/boot/dts/qcom/Makefile b/arch/arm64/boot/dts/qcom/Makefile
index 7b5466395f46..834e790bec90 100644
--- a/arch/arm64/boot/dts/qcom/Makefile
+++ b/arch/arm64/boot/dts/qcom/Makefile
@@ -12,6 +12,7 @@ dtb-$(CONFIG_ARCH_QCOM)	+= ipq8074-hk10-c2.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= ipq9574-rdp418.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= ipq9574-rdp433.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= ipq9574-rdp449.dtb
+dtb-$(CONFIG_ARCH_QCOM)	+= ipq9574-rdp454.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= msm8916-acer-a1-724.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= msm8916-alcatel-idol347.dtb
  dtb-$(CONFIG_ARCH_QCOM)	+= msm8916-asus-z00l.dtb
diff --git a/arch/arm64/boot/dts/qcom/ipq9574-rdp454.dts b/arch/arm64/boot/dts/qcom/ipq9574-rdp454.dts
new file mode 100644
index 000000000000..b3e853a9cc94
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/ipq9574-rdp454.dts
@@ -0,0 +1,92 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
+/*
+ * IPQ9574 RDP454 board device tree source
+ *
+ * Copyright (c) 2020-2021 The Linux Foundation. All rights reserved.
+ * Copyright (c) 2022-2023 Qualcomm Innovation Center, Inc. All rights reserved.
+ */
+
+/dts-v1/;
+
+#include "ipq9574.dtsi"
+
+/ {
+	model = "Qualcomm Technologies, Inc. IPQ9574/AP-AL02-C9";
+	compatible = "qcom,ipq9574-ap-al02-c9", "qcom,ipq9574";
+
+	aliases {
+		serial0 = &blsp1_uart2;
+	};
+
+	chosen {
+		stdout-path = "serial0:115200n8";
+	};
+};
+
+/* In AL02-C9, the max supported CPU Freq is 1.5 GHz. Disabling frequencies beyond 1.5GHz*/
In -> On

GHz*/ -> GHz */

Disabling -> Disable
Okay. Will address them in next spin

Can this not be determined based on fuse values?

Yes...That should be possible.Will then drop the below cpu_opp_table entries and post a separate series for the same.


+&cpu_opp_table {
+	opp-1800000000 {
+		opp-supported-hw = <0>;
+	};
+
+	opp-2208000000 {
+		opp-supported-hw = <0>;
+	};
+};
+
+/* Disable IPQ9574 integrated radio's reserved memory */
?

Konrad

sorry, will drop it as it got added by mistake.

Regards,
Poovendhan S

+&blsp1_spi0 {
+	pinctrl-0 = <&spi_0_pins>;
+	pinctrl-names = "default";
+	status = "okay";
+
+	flash@0 {
+		compatible = "micron,n25q128a11", "jedec,spi-nor";
+		reg = <0>;
+		#address-cells = <1>;
+		#size-cells = <1>;
+		spi-max-frequency = <50000000>;
+	};
+};
+
+&blsp1_uart2 {
+	pinctrl-0 = <&uart2_pins>;
+	pinctrl-names = "default";
+	status = "okay";
+};
+
+&rpm_requests {
+	regulators {
+		compatible = "qcom,rpm-mp5496-regulators";
+
+		ipq9574_s1: s1 {
+		/*
+		 * During kernel bootup, the SoC runs at 800MHz with 875mV set by the bootloaders.
+		 * During regulator registration, kernel not knowing the initial voltage,
+		 * considers it as zero and brings up the regulators with minimum supported voltage.
+		 * Update the regulator-min-microvolt with SVS voltage of 725mV so that
+		 * the regulators are brought up with 725mV which is sufficient for all the
+		 * corner parts to operate at 800MHz
+		 */
+			regulator-min-microvolt = <725000>;
+			regulator-max-microvolt = <1075000>;
+		};
+	};
+};
+
+&sleep_clk {
+	clock-frequency = <32000>;
+};
+
+&tlmm {
+	spi_0_pins: spi-0-state {
+		pins = "gpio11", "gpio12", "gpio13", "gpio14";
+		function = "blsp0_spi";
+		drive-strength = <8>;
+		bias-disable;
+	};
+};
+
+&xo_board_clk {
+	clock-frequency = <24000000>;
+};



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux