Re: [PATCH 1/2] dt-bindings: pinctrl: qcom: Add SDX75 pinctrl devicetree compatible

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 18 May 2023 at 16:53, Rohit Agarwal <quic_rohiagar@xxxxxxxxxxx> wrote:
>
> Add device tree binding Documentation details for Qualcomm SDX75
> pinctrl driver.
>
> Signed-off-by: Rohit Agarwal <quic_rohiagar@xxxxxxxxxxx>
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> ---
>  .../bindings/pinctrl/qcom,sdx75-tlmm.yaml          | 137 +++++++++++++++++++++
>  1 file changed, 137 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/pinctrl/qcom,sdx75-tlmm.yaml
>
> diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,sdx75-tlmm.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,sdx75-tlmm.yaml
> new file mode 100644
> index 0000000..7cb96aa
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/pinctrl/qcom,sdx75-tlmm.yaml
> @@ -0,0 +1,137 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/pinctrl/qcom,sdx75-tlmm.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: Qualcomm Technologies, Inc. SDX75 TLMM block
> +
> +maintainers:
> +  - Rohit Agarwal <quic_rohiagar@xxxxxxxxxxx>
> +
> +description:
> +  Top Level Mode Multiplexer pin controller in Qualcomm SDX75 SoC.
> +
> +allOf:
> +  - $ref: /schemas/pinctrl/qcom,tlmm-common.yaml#
> +
> +properties:
> +  compatible:
> +    const: qcom,sdx75-tlmm
> +
> +  reg:
> +    maxItems: 1
> +
> +  interrupts: true
> +  interrupt-controller: true
> +  "#interrupt-cells": true
> +  gpio-controller: true
> +
> +  gpio-reserved-ranges:
> +    minItems: 1
> +    maxItems: 67
> +
> +  gpio-line-names:
> +    maxItems: 133
> +
> +  "#gpio-cells": true
> +  gpio-ranges: true
> +  wakeup-parent: true
> +
> +patternProperties:
> +  "-state$":
> +    oneOf:
> +      - $ref: "#/$defs/qcom-sdx75-tlmm-state"
> +      - patternProperties:
> +          "-pins$":
> +            $ref: "#/$defs/qcom-sdx75-tlmm-state"
> +        additionalProperties: false
> +
> +$defs:
> +  qcom-sdx75-tlmm-state:
> +    type: object
> +    description:
> +      Pinctrl node's client devices use subnodes for desired pin configuration.
> +      Client device subnodes use below standard properties.
> +    $ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state
> +    unevaluatedProperties: false
> +
> +    properties:
> +      pins:
> +        description:
> +          List of gpio pins affected by the properties specified in this
> +          subnode.
> +        items:
> +          oneOf:
> +            - pattern: "^gpio([0-9]|[1-9][0-9]|1[0-2][0-9]|13[0-2])$"
> +            - enum: [ sdc1_clk, sdc1_cmd, sdc1_data, sdc1_rclk, sdc2_clk, sdc2_cmd, sdc2_data ]
> +        minItems: 1
> +        maxItems: 36
> +
> +      function:
> +        description:
> +          Specify the alternative function to be configured for the specified
> +          pins.
> +        enum: [ adsp_ext, atest_char, audio_ref_clk, bimc_dte, char_exec, coex_uart2,
> +                coex_uart, cri_trng, cri_trng0, cri_trng1, dbg_out_clk, ddr_bist,
> +                ddr_pxi0, ebi0_wrcdc, ebi2_a, ebi2_lcd, ebi2_lcd_te, emac0_mcg,
> +                emac0_ptp, emac1_mcg, emac1_ptp, emac_cdc, emac_pps_in, eth0_mdc,
> +                eth0_mdio, eth1_mdc, eth1_mdio, ext_dbg, gcc_125_clk, gcc_gp1_clk,
> +                gcc_gp2_clk, gcc_gp3_clk, gcc_plltest, gpio, i2s_mclk, jitter_bist,
> +                ldo_en, ldo_update, m_voc, mgpi_clk, native_char, native_tsens,
> +                native_tsense, nav_dr_sync, nav_gpio, pa_indicator, pci_e,
> +                pcie0_clkreq_n, pcie1_clkreq_n, pcie2_clkreq_n, pll_bist_sync,
> +                pll_clk_aux, pll_ref_clk, pri_mi2s, prng_rosc, qdss_cti, qdss_gpio,
> +                qlink0_b_en, qlink0_b_req, qlink0_l_en, qlink0_l_req, qlink0_wmss,
> +                qlink1_l_en, qlink1_l_req, qlink1_wmss, qup_se0, qup_se1_l2_mira,
> +                qup_se1_l2_mirb, qup_se1_l3_mira, qup_se1_l3_mirb, qup_se2, qup_se3,
> +                qup_se4, qup_se5, qup_se6, qup_se7, qup_se8, rgmii_rx_ctl, rgmii_rxc,
> +                rgmii_rxd, rgmii_tx_ctl, rgmii_txc, rgmii_txd, sd_card, sdc1_tb,
> +                sdc2_tb_trig, sec_mi2s, sgmii_phy_intr0_n, sgmii_phy_intr1_n,
> +                spmi_coex, spmi_vgi, tgu_ch0_trigout, tmess_prng0, tmess_prng1,
> +                tmess_prng2, tmess_prng3, tri_mi2s, uim1_clk, uim1_data, uim1_present,
> +                uim1_reset, uim2_clk, uim2_data, uim2_present, uim2_reset,
> +                usb2phy_ac_en, vsense_trigger_mirnat]
> +
> +    required:
> +      - pins
> +
> +required:
> +  - compatible
> +  - reg
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    tlmm: pinctrl@f100000 {
> +        compatible = "qcom,sdx75-tlmm";
> +        reg = <0x0f100000 0x300000>;
> +        gpio-controller;
> +        #gpio-cells = <2>;
> +        gpio-ranges = <&tlmm 0 0 133>;
> +        interrupt-controller;
> +        #interrupt-cells = <2>;
> +        interrupts = <GIC_SPI 208 IRQ_TYPE_LEVEL_HIGH>;
> +
> +        gpio-wo-state {
> +            pins = "gpio1";
> +            function = "gpio";
> +        };
> +
> +        uart-w-state {
> +            rx-pins {
> +                pins = "gpio12";
> +                function = "qup_se1_l2_mira";
> +                bias-disable;
> +            };
> +
> +            tx-pins {
> +                pins = "gpio13";
> +                function = "qup_se1_l3_mira";
> +                bias-disable;
> +            };
> +        };
> +    };
> +...
> --
> 2.7.4

While at it, please also send a separate patch to add pinctrl yaml
file entries in MAINTAINERS, which currently contains:

F:    Documentation/devicetree/bindings/pinctrl/qcom,*.txt

without which $ ./scripts/get_maintainer.pl would not indicate correct
results for your yaml dt-binding addition.

Thanks,
Bhupesh



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux