On Sun, 7 May 2023 18:43:16 +0300
Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> wrote:
> On 02/05/2023 02:17, Marijn Suijten wrote:
> > Set the read_label() callback to return a friendly name provided in DT
> > (firmware), in order to make in_{therm,voltage}X_label attributes show
> > up in sysfs for userspace to consume a channel name. This is
> > particularly useful for custom thermistors being attached to otherwise
> > generically named GPIOs, where the name is known by the board DT.
> >
> > If the channel name isn't set in DT, use the datasheet_name hardcoded in
> > the driver instead.
> >
> > Note that this doesn't fall back to fwnode_get_name() as that provides
> > suboptimally readable names, with an @xx address suffix from board DT.
> >
> > Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
> > ---
> > drivers/iio/adc/qcom-spmi-vadc.c | 19 ++++++++++++++++++-
> > 1 file changed, 18 insertions(+), 1 deletion(-)
>
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
>
Thanks,
Series applied to the togreg branch of iio.git - initially pushed out
as testing to let 0-day work it's magic before I go potentially making
a mess in linux-next.
Jonathan
