Re: [PATCH RESEND v3 2/5] iio: adc: qcom-spmi-adc5: Use driver datasheet_name instead of DT label

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 02/05/2023 02:17, Marijn Suijten wrote:
iio_chan_spec::datasheet_name expects a channel/pin name on the hardware
part, i.e. from its datasheet, instead of a friendly name from DT which
typically describes the use of said channel.  GPIO channels are commonly
specialized in QCOM board DTS based on what a - typically thermistor -
is connected to.

Also rename adc5_channel_prop::datasheet_name to channel_name to that
effect.

Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
---
  drivers/iio/adc/qcom-spmi-adc5.c | 10 +++++-----
  1 file changed, 5 insertions(+), 5 deletions(-)

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

--
With best wishes
Dmitry




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux