This small series fix a current problem with ipq8074 where the 2 uniphy port doesn't work in some corner case with some clk configuration. The port to correctly work require a specific frequency, using the wrong one results in the port not transmitting data. With the current code with a requested freq of 125MHz, the frequency is set to 105MHz. This is caused by the fact that there are 2 different configuration to set 125MHz and it's always selected the first one that results in 105MHz. In the original QSDK code, the frequency configuration selection is different and the CEIL FLOOR logic is not present. Instead it's used a BEST approach where the frequency table is checked and then it's checked if there are duplicate entry. This proposed implementation is more specific and introduce an entire new set of ops and a specific freq table to support this special configuration. A union is introduced in rcg2 struct to not duplicate the struct. A new set of ops clk_rcg2_fm_ops are introduced to support this new kind of frequency table. Changes v4: - Drop suggested but wrong re-search patch - Move everything to separate ops and struct to not affect current rcg2 users. Changes v3: - Add qcom_find_freq_exact - Drop re-search on rcg2_set_rate - Rework multiple conf patch to follow new implementation Changes v2: - Out of RFC - Fix compile warning from buildbot related to F redefinition Christian Marangi (3): clk: qcom: clk-rcg: introduce support for multiple conf for same freq clk: qcom: clk-rcg2: add support for rcg2 freq multi ops clk: qcom: gcc-ipq8074: rework nss_port5/6 clock to multiple conf drivers/clk/qcom/clk-rcg.h | 24 +++++- drivers/clk/qcom/clk-rcg2.c | 152 +++++++++++++++++++++++++++++++++ drivers/clk/qcom/common.c | 18 ++++ drivers/clk/qcom/common.h | 2 + drivers/clk/qcom/gcc-ipq8074.c | 120 ++++++++++++++++---------- 5 files changed, 271 insertions(+), 45 deletions(-) -- 2.39.2
