Re: [Freedreno] [PATCH 03/11] drm/msm/dpu: use hsync/vsync polarity set by the encoder

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 4/19/2023 7:41 AM, Arnaud Vrac wrote:
Do not override the hsync/vsync polarity passed by the encoder when
setting up intf timings. The same logic was used in both the encoder and
intf code to set the DP and DSI polarities, so those interfaces are not
impacted. However for HDMI, the polarities were overriden to static
values based on the vertical resolution, instead of using the actual
mode polarities.

Any idea why vres based static polarity override was in place? Hope you had tested HDMI resolutions with yres > and < than 720.

Jeykumar S.

Signed-off-by: Arnaud Vrac <avrac@xxxxxxxxxx>
---
  drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 16 +++-------------
  1 file changed, 3 insertions(+), 13 deletions(-)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
index 84ee2efa9c664..9f05417eb1213 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
@@ -104,7 +104,7 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
  	u32 active_h_start, active_h_end;
  	u32 active_v_start, active_v_end;
  	u32 active_hctl, display_hctl, hsync_ctl;
-	u32 polarity_ctl, den_polarity, hsync_polarity, vsync_polarity;
+	u32 polarity_ctl, den_polarity;
  	u32 panel_format;
  	u32 intf_cfg, intf_cfg2 = 0;
  	u32 display_data_hctl = 0, active_data_hctl = 0;
@@ -191,19 +191,9 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
  	}
den_polarity = 0;
-	if (ctx->cap->type == INTF_HDMI) {
-		hsync_polarity = p->yres >= 720 ? 0 : 1;
-		vsync_polarity = p->yres >= 720 ? 0 : 1;
-	} else if (ctx->cap->type == INTF_DP) {
-		hsync_polarity = p->hsync_polarity;
-		vsync_polarity = p->vsync_polarity;
-	} else {
-		hsync_polarity = 0;
-		vsync_polarity = 0;
-	}
  	polarity_ctl = (den_polarity << 2) | /*  DEN Polarity  */
-		(vsync_polarity << 1) | /* VSYNC Polarity */
-		(hsync_polarity << 0);  /* HSYNC Polarity */
+		(p->vsync_polarity << 1) | /* VSYNC Polarity */
+		(p->hsync_polarity << 0);  /* HSYNC Polarity */
if (!DPU_FORMAT_IS_YUV(fmt))
  		panel_format = (fmt->bits[C0_G_Y] |




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux