On Fri, Apr 07, 2023 at 07:58:02PM +0200, Krzysztof Kozlowski wrote:
> Pin configuration property "input-enable" was used with the intention to
> disable the output, but this is done by default by Linux drivers. Since
> patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
> input-enable") the property is not accepted anymore.
This description does not seem to match the pin configurations that you
are changing below which use the "qcom,sc8280xp-lpass-lpi-pinctrl"
binding for which 'input-enable' is still accepted AFAICT.
Perhaps you can fix up the lpass bindings (and driver?) to match?
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/sc8280xp.dtsi | 4 ----
> 1 file changed, 4 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> index 4c75da1bac2d..5632c3b8e416 100644
> --- a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> @@ -2728,7 +2728,6 @@ data-pins {
> pins = "gpio7";
> function = "dmic1_data";
> drive-strength = <8>;
> - input-enable;
> };
> };
Johan
