All Qualcomm SoC Top Level Mode Multiplexer pin controllers have similar
capabilities regarding pin properties, thus we can just accept entire
set provided by qcom,tlmm-common.yaml schema.
This also fixes warnings like:
sc7280-herobrine-evoker.dtb: pinctrl@f100000: qspi-sleep-state: 'oneOf' conditional failed, one must be fixed:
'output-disable' does not match any of the regexes: 'pinctrl-[0-9]+'
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
.../bindings/pinctrl/qcom,sc7280-pinctrl.yaml | 12 +-----------
1 file changed, 1 insertion(+), 11 deletions(-)
diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml
index 36502173cb79..368d44ff5468 100644
--- a/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml
@@ -62,6 +62,7 @@ $defs:
Pinctrl node's client devices use subnodes for desired pin configuration.
Client device subnodes use below standard properties.
$ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state
+ unevaluatedProperties: false
properties:
pins:
@@ -110,20 +111,9 @@ $defs:
uim1_clk, uim1_data, uim1_present, uim1_reset, usb2phy_ac,
usb_phy, vfr_0, vfr_1, vsense_trigger ]
- bias-pull-down: true
- bias-pull-up: true
- bias-bus-hold: true
- bias-disable: true
- drive-strength: true
- input-enable: true
- output-high: true
- output-low: true
-
required:
- pins
- additionalProperties: false
-
allOf:
- $ref: /schemas/pinctrl/qcom,tlmm-common.yaml#
--
2.34.1
