Re: [PATCH v3 3/3] arm64: dts: qcom: sa8540p-ride: Add ethernet nodes

[Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>]

On 31/03/2023 23:58, Andrew Halaney wrote:
> Enable both the MACs found on the board.
> 
> ethernet0 and ethernet1 both ultimately go to a series of on board
> switches which aren't managed by this processor.

>  
> +&ethernet0 {
> +	snps,mtl-rx-config = <&mtl_rx_setup>;
> +	snps,mtl-tx-config = <&mtl_tx_setup>;
> +
> +	max-speed = <1000>;
> +	phy-handle = <&rgmii_phy>;
> +	phy-mode = "rgmii-txid";
> +
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&ethernet0_default>;
> +
> +	status = "okay";
> +
> +	mdio {
> +		#address-cells = <0x1>;
> +		#size-cells = <0x0>;
> +
> +		compatible = "snps,dwmac-mdio";

Compatible is always, always the first property.

Best regards,
Krzysztof