The soc node is supposed to have only device nodes with MMIO addresses,
so move the DSI OPP into the DSI controller node to fix:
sda660-inforce-ifc6560.dtb: soc: opp-table-dsi: {'compatible': ['operating-points-v2'], ... should not be valid under {'type': 'object'}
From schema: dtschema/schemas/simple-bus.yaml
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sdm630.dtsi | 38 ++++++++++++++--------------
1 file changed, 19 insertions(+), 19 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sdm630.dtsi b/arch/arm64/boot/dts/qcom/sdm630.dtsi
index 5add1951d963..ef63aa86ad67 100644
--- a/arch/arm64/boot/dts/qcom/sdm630.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm630.dtsi
@@ -1450,25 +1450,6 @@ mmcc: clock-controller@c8c0000 {
<0>;
};
- dsi_opp_table: opp-table-dsi {
- compatible = "operating-points-v2";
-
- opp-131250000 {
- opp-hz = /bits/ 64 <131250000>;
- required-opps = <&rpmpd_opp_svs>;
- };
-
- opp-210000000 {
- opp-hz = /bits/ 64 <210000000>;
- required-opps = <&rpmpd_opp_svs_plus>;
- };
-
- opp-262500000 {
- opp-hz = /bits/ 64 <262500000>;
- required-opps = <&rpmpd_opp_nom>;
- };
- };
-
mdss: display-subsystem@c900000 {
compatible = "qcom,mdss";
reg = <0x0c900000 0x1000>,
@@ -1610,6 +1591,25 @@ dsi0: dsi@c994000 {
status = "disabled";
+ dsi_opp_table: opp-table {
+ compatible = "operating-points-v2";
+
+ opp-131250000 {
+ opp-hz = /bits/ 64 <131250000>;
+ required-opps = <&rpmpd_opp_svs>;
+ };
+
+ opp-210000000 {
+ opp-hz = /bits/ 64 <210000000>;
+ required-opps = <&rpmpd_opp_svs_plus>;
+ };
+
+ opp-262500000 {
+ opp-hz = /bits/ 64 <262500000>;
+ required-opps = <&rpmpd_opp_nom>;
+ };
+ };
+
ports {
#address-cells = <1>;
#size-cells = <0>;
--
2.34.1
