The register QPHY_V[34]_PCS_MISC_CLAMP_ENABLE is present only on some
SoC families. Other platforms (qcm2290) can have PCS_MISC region, but do
not have this register. Add it to the register layout table and check
that it is defined before toggling CLAMP settings.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
drivers/phy/qualcomm/phy-qcom-qmp-usb.c | 22 +++++++++++++++++-----
1 file changed, 17 insertions(+), 5 deletions(-)
diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-usb.c b/drivers/phy/qualcomm/phy-qcom-qmp-usb.c
index a49711c5a63d..269350687259 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-usb.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-usb.c
@@ -95,6 +95,7 @@ enum qphy_reg_layout {
QPHY_PCS_AUTONOMOUS_MODE_CTRL,
QPHY_PCS_LFPS_RXTERM_IRQ_CLEAR,
QPHY_PCS_POWER_DOWN_CONTROL,
+ QPHY_PCS_MISC_CLAMP_ENABLE,
/* Keep last to ensure regs_layout arrays are properly initialized */
QPHY_LAYOUT_SIZE
};
@@ -115,6 +116,16 @@ static const unsigned int qmp_v3_usb3phy_regs_layout[QPHY_LAYOUT_SIZE] = {
[QPHY_PCS_AUTONOMOUS_MODE_CTRL] = QPHY_V3_PCS_AUTONOMOUS_MODE_CTRL,
[QPHY_PCS_LFPS_RXTERM_IRQ_CLEAR] = QPHY_V3_PCS_LFPS_RXTERM_IRQ_CLEAR,
[QPHY_PCS_POWER_DOWN_CONTROL] = QPHY_V3_PCS_POWER_DOWN_CONTROL,
+ [QPHY_PCS_MISC_CLAMP_ENABLE] = QPHY_V3_PCS_MISC_CLAMP_ENABLE,
+};
+
+static const unsigned int qmp_v3_usb3phy_regs_layout_qcm2290[QPHY_LAYOUT_SIZE] = {
+ [QPHY_SW_RESET] = QPHY_V3_PCS_SW_RESET,
+ [QPHY_START_CTRL] = QPHY_V3_PCS_START_CONTROL,
+ [QPHY_PCS_STATUS] = QPHY_V3_PCS_PCS_STATUS,
+ [QPHY_PCS_AUTONOMOUS_MODE_CTRL] = QPHY_V3_PCS_AUTONOMOUS_MODE_CTRL,
+ [QPHY_PCS_LFPS_RXTERM_IRQ_CLEAR] = QPHY_V3_PCS_LFPS_RXTERM_IRQ_CLEAR,
+ [QPHY_PCS_POWER_DOWN_CONTROL] = QPHY_V3_PCS_POWER_DOWN_CONTROL,
};
static const unsigned int qmp_v4_usb3phy_regs_layout[QPHY_LAYOUT_SIZE] = {
@@ -126,6 +137,7 @@ static const unsigned int qmp_v4_usb3phy_regs_layout[QPHY_LAYOUT_SIZE] = {
/* In PCS_USB */
[QPHY_PCS_AUTONOMOUS_MODE_CTRL] = QPHY_V4_PCS_USB3_AUTONOMOUS_MODE_CTRL,
[QPHY_PCS_LFPS_RXTERM_IRQ_CLEAR] = QPHY_V4_PCS_USB3_LFPS_RXTERM_IRQ_CLEAR,
+ [QPHY_PCS_MISC_CLAMP_ENABLE] = QPHY_V4_PCS_MISC_CLAMP_ENABLE,
};
static const unsigned int qmp_v5_usb3phy_regs_layout[QPHY_LAYOUT_SIZE] = {
@@ -1936,7 +1948,7 @@ static const struct qmp_phy_cfg qcm2290_usb3phy_cfg = {
.num_resets = ARRAY_SIZE(qcm2290_usb3phy_reset_l),
.vreg_list = qmp_phy_vreg_l,
.num_vregs = ARRAY_SIZE(qmp_phy_vreg_l),
- .regs = qmp_v3_usb3phy_regs_layout,
+ .regs = qmp_v3_usb3phy_regs_layout_qcm2290,
};
static void qmp_usb_configure_lane(void __iomem *base,
@@ -2198,8 +2210,8 @@ static void qmp_usb_enable_autonomous_mode(struct qmp_usb *qmp)
qphy_setbits(pcs_usb, cfg->regs[QPHY_PCS_AUTONOMOUS_MODE_CTRL], intr_mask);
/* Enable i/o clamp_n for autonomous mode */
- if (pcs_misc)
- qphy_clrbits(pcs_misc, QPHY_V3_PCS_MISC_CLAMP_ENABLE, CLAMP_EN);
+ if (pcs_misc && cfg->regs[QPHY_PCS_MISC_CLAMP_ENABLE])
+ qphy_clrbits(pcs_misc, cfg->regs[QPHY_PCS_MISC_CLAMP_ENABLE], CLAMP_EN);
}
static void qmp_usb_disable_autonomous_mode(struct qmp_usb *qmp)
@@ -2209,8 +2221,8 @@ static void qmp_usb_disable_autonomous_mode(struct qmp_usb *qmp)
void __iomem *pcs_misc = qmp->pcs_misc;
/* Disable i/o clamp_n on resume for normal mode */
- if (pcs_misc)
- qphy_setbits(pcs_misc, QPHY_V3_PCS_MISC_CLAMP_ENABLE, CLAMP_EN);
+ if (pcs_misc && cfg->regs[QPHY_PCS_MISC_CLAMP_ENABLE])
+ qphy_setbits(pcs_misc, cfg->regs[QPHY_PCS_MISC_CLAMP_ENABLE], CLAMP_EN);
qphy_clrbits(pcs_usb, cfg->regs[QPHY_PCS_AUTONOMOUS_MODE_CTRL],
ARCVR_DTCT_EN | ARCVR_DTCT_EVENT_SEL | ALFPS_DTCT_EN);
--
2.30.2
