[RESEND PATCH 4/4] arm64: dts: qcom: qrb5165-rb5: Use proper WSA881x shutdown GPIO polarity

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The WSA881x shutdown GPIO is active low (SD_N), but Linux driver assumed
DTS always comes with active high.  Since Linux drivers were updated to
handle proper flag, correct the DTS.

The change is not backwards compatible with older Linux kernel.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/qrb5165-rb5.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
index aa0a7bd7307c..dd924331b0ee 100644
--- a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
+++ b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
@@ -1012,7 +1012,7 @@ &swr0 {
 	left_spkr: speaker@0,3 {
 		compatible = "sdw10217211000";
 		reg = <0 3>;
-		powerdown-gpios = <&tlmm 130 GPIO_ACTIVE_HIGH>;
+		powerdown-gpios = <&tlmm 130 GPIO_ACTIVE_LOW>;
 		#thermal-sensor-cells = <0>;
 		sound-name-prefix = "SpkrLeft";
 		#sound-dai-cells = <0>;
@@ -1021,7 +1021,7 @@ left_spkr: speaker@0,3 {
 	right_spkr: speaker@0,4 {
 		compatible = "sdw10217211000";
 		reg = <0 4>;
-		powerdown-gpios = <&tlmm 130 GPIO_ACTIVE_HIGH>;
+		powerdown-gpios = <&tlmm 130 GPIO_ACTIVE_LOW>;
 		#thermal-sensor-cells = <0>;
 		sound-name-prefix = "SpkrRight";
 		#sound-dai-cells = <0>;
-- 
2.34.1




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux