Re: [PATCH v3 0/9] arm64: dts: qcom: sa8775p-ride: enable relevant QUPv3 IPs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Feb 16, 2023 at 1:53 PM Bartosz Golaszewski <brgl@xxxxxxxx> wrote:
>
> From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
>
> This enables the QUPv3 interfaces that are exposed on the sa8775p-ride
> board: I2C, SPI and the Bluetooth and GNSS UART ports.
>
> v2 -> v3:
> - fix the interrupt number for uart12
> - replace underscores with hyphens in DT node names (although make dtbs_check
>   does not raise warnings about this)
> - rearrange the commits so that they're more fine-grained with separate
>   patches for adding nodes to dtsi and enabling them for the board
>
> v1 -> v2:
> - uart17 is the Bluetooth port, not GNSS
> - add uart12 for GNSS too in that case
>
> Bartosz Golaszewski (9):
>   arm64: dts: qcom: sa8775p: add the QUPv3 #2 node
>   arm64: dts: qcom: sa8775p-ride: enable QUPv3 #2
>   arm64: dts: qcom: sa8775p: add the i2c18 node
>   arm64: dts: qcom: sa8775p-ride: enable i2c18
>   arm64: dts: qcom: sa8775p: add the spi16 node
>   arm64: dts: qcom: sa8775p-ride: enable the SPI node
>   arm64: dts: qcom: sa8775p: add high-speed UART nodes
>   arm64: dts: qcom: sa8775p-ride: enable the GNSS UART port
>   arm64: dts: qcom: sa8775p-ride: enable the BT UART port
>
>  arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 100 ++++++++++++++++++++++
>  arch/arm64/boot/dts/qcom/sa8775p.dtsi     |  86 +++++++++++++++++++
>  2 files changed, 186 insertions(+)
>
> --
> 2.37.2
>

Konrad, Krzysztof et al,

It's been over two weeks, could you please take a look and let me know
if this is good to go?

Thanks,
Bartosz




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux