GPIO output type configuration was incorrectly overwritten by strength value. Fix this. Signed-off-by: Ivan T. Ivanov <ivan.ivanov@xxxxxxxxxx> --- drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c index b2d2221..4b21aac 100644 --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c @@ -417,7 +417,7 @@ static int pmic_gpio_config_set(struct pinctrl_dev *pctldev, unsigned int pin, return ret; val = pad->buffer_type << PMIC_GPIO_REG_OUT_TYPE_SHIFT; - val = pad->strength << PMIC_GPIO_REG_OUT_STRENGTH_SHIFT; + val |= pad->strength << PMIC_GPIO_REG_OUT_STRENGTH_SHIFT; ret = pmic_gpio_write(state, pad, PMIC_GPIO_REG_DIG_OUT_CTL, val); if (ret < 0) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
