On Mon, Mar 23 2015 at 17:38 -0600, Kumar Gala wrote:
On Mar 23, 2015, at 4:15 PM, Lina Iyer <lina.iyer@xxxxxxxxxx> wrote:
On Mon, Mar 23 2015 at 16:06 -0600, Kumar Gala wrote:
On Mar 20, 2015, at 1:21 PM, Lina Iyer <lina.iyer@xxxxxxxxxx> wrote:
Based on work by: Mahesh Sivasubramanian <msivasub@xxxxxxxxxxxxxx>,
Ai Li <ali@xxxxxxxxxxxxxx>, Praveen Chidambaram <pchidamb@xxxxxxxxxxxxxx>
Original tree available at -
git://codeaurora.org/quic/la/kernel/msm-3.10.git
Cc: Stephen Boyd <sboyd@xxxxxxxxxxxxxx>
Cc: Arnd Bergmann <arnd@xxxxxxxx>
Cc: Kevin Hilman <khilman@xxxxxxxxxx>
Cc: Daniel Lezcano <daniel.lezcano@xxxxxxxxxx>
Signed-off-by: Lina Iyer <lina.iyer@xxxxxxxxxx>
---
.../devicetree/bindings/arm/msm/qcom,saw2.txt | 29 +-
drivers/soc/qcom/Kconfig | 7 +
drivers/soc/qcom/Makefile | 1 +
drivers/soc/qcom/spm.c | 405 +++++++++++++++++++++
4 files changed, 436 insertions(+), 6 deletions(-)
create mode 100644 drivers/soc/qcom/spm.c
diff --git a/Documentation/devicetree/bindings/arm/msm/qcom,saw2.txt b/Documentation/devicetree/bindings/arm/msm/qcom,saw2.txt
index 1505fb8..664aa91 100644
--- a/Documentation/devicetree/bindings/arm/msm/qcom,saw2.txt
+++ b/Documentation/devicetree/bindings/arm/msm/qcom,saw2.txt
@@ -2,11 +2,20 @@ SPM AVS Wrapper 2 (SAW2)
The SAW2 is a wrapper around the Subsystem Power Manager (SPM) and the
Adaptive Voltage Scaling (AVS) hardware. The SPM is a programmable
-micro-controller that transitions a piece of hardware (like a processor or
+power-controller that transitions a piece of hardware (like a processor or
subsystem) into and out of low power modes via a direct connection to
the PMIC. It can also be wired up to interact with other processors in the
system, notifying them when a low power state is entered or exited.
+Multiple revisions of the SAW hardware are supported using these Device Nodes.
+SAW2 revisions differ in the register offset and configuration data. Also, the
+same revision of the SAW in different SoCs may have different configuration
+data due the the differences in hardware capabilities. Hence the SoC name, the
+version of the SAW hardware in that SoC and the distinction between cpu (big
+or Little) or cache, may be needed to uniquely identify the SAW register
+configuration and initialization data. The compatible string is used to
+indicate this parameter.
+
PROPERTIES
- compatible:
@@ -14,10 +23,11 @@ PROPERTIES
Value type: <string>
Definition: shall contain "qcom,saw2". A more specific value should be
one of:
Does “qcom,saw2” have any meaning anymore? I see we use it in some places, but not everywhere on the .dts. We also see to have the L2 just be a “qcom,saw2” node, do we expect that to change?
It does help match a regulator node as opposed to the specific values
below.
Than we should cleanup the wording. Right now it reads such that ‘qcom,saw2’ is always required.
Ah Ok. Sure. I will respin a new patchset.
Anything else?
- "qcom,saw2-v1"
- "qcom,saw2-v1.1"
- "qcom,saw2-v2"
- "qcom,saw2-v2.1"
+ "qcom,saw2-v2"
+ "qcom,saw2-v2.1"
+ "qcom,apq8064-saw2-v1.1-cpu"
+ "qcom,msm8974-saw2-v2.1-cpu"
+ "qcom,apq8084-saw2-v2.1-cpu"
- reg:
Usage: required
@@ -26,10 +36,17 @@ PROPERTIES
the register region. An optional second element specifies
the base address and size of the alias register region.
+- regulator:
+ Usage: optional
+ Value type: boolean
+ Definition: Indicates that this SPM device acts as a regulator device
+ device for the core (CPU or Cache) the SPM is attached
+ to.
Example:
- regulator@2099000 {
+ power-controller@2099000 {
compatible = "qcom,saw2";
reg = <0x02099000 0x1000>, <0x02009000 0x1000>;
+ regulator;
};
- k
--
Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
