On SM8550, depending on the Qunipro, we can run with G5 or G4.
For now, when the major version is 5 or above, we go with G5.
Therefore, we need to specifically tell UFS HC that.
Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
---
drivers/ufs/host/ufs-qcom.c | 8 ++++++--
drivers/ufs/host/ufs-qcom.h | 6 +++++-
2 files changed, 11 insertions(+), 3 deletions(-)
diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 5e7ba3b6a59d..7b6deef4e49a 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -218,6 +218,10 @@ static void ufs_qcom_select_unipro_mode(struct ufs_qcom_host *host)
ufshcd_rmwl(host->hba, QUNIPRO_SEL,
ufs_qcom_cap_qunipro(host) ? QUNIPRO_SEL : 0,
REG_UFS_CFG1);
+
+ if (host->hw_ver.major == 0x05)
+ ufshcd_rmwl(host->hba, QUNIPRO_G4_SEL, 0, REG_UFS_CFG0);
+
/* make sure above configuration is applied before we return */
mb();
}
@@ -507,9 +511,9 @@ static int ufs_qcom_cfg_timers(struct ufs_hba *hba, u32 gear,
mb();
}
- if (update_link_startup_timer) {
+ if (update_link_startup_timer && host->hw_ver.major != 0x5) {
ufshcd_writel(hba, ((core_clk_rate / MSEC_PER_SEC) * 100),
- REG_UFS_PA_LINK_STARTUP_TIMER);
+ REG_UFS_CFG0);
/*
* make sure that this configuration is applied before
* we return
diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
index f744a9e62002..cca773210bcb 100644
--- a/drivers/ufs/host/ufs-qcom.h
+++ b/drivers/ufs/host/ufs-qcom.h
@@ -35,7 +35,8 @@ enum {
REG_UFS_PA_ERR_CODE = 0xCC,
/* On older UFS revisions, this register is called "RETRY_TIMER_REG" */
REG_UFS_PARAM0 = 0xD0,
- REG_UFS_PA_LINK_STARTUP_TIMER = 0xD8,
+ /* On older UFS revisions, this register is called "REG_UFS_PA_LINK_STARTUP_TIMER" */
+ REG_UFS_CFG0 = 0xD8,
REG_UFS_CFG1 = 0xDC,
REG_UFS_CFG2 = 0xE0,
REG_UFS_HW_VERSION = 0xE4,
@@ -73,6 +74,9 @@ enum {
#define UFS_CNTLR_2_x_x_VEN_REGS_OFFSET(x) (0x000 + x)
#define UFS_CNTLR_3_x_x_VEN_REGS_OFFSET(x) (0x400 + x)
+/* bit definitions for REG_UFS_CFG0 register */
+#define QUNIPRO_G4_SEL BIT(5)
+
/* bit definitions for REG_UFS_CFG1 register */
#define QUNIPRO_SEL BIT(0)
#define UFS_PHY_SOFT_RESET BIT(1)
--
2.34.1
