[PATCH Resend v11 13/15] drm/msm/disp/dpu: reset the datapath after timing engine disable

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Reset the datapath after disabling the timing gen, such that
it can start on a clean slate when the intf is enabled back.
This was a recommended sequence from the DPU HW programming guide.

Signed-off-by: Vinod Polimera <quic_vpolimer@xxxxxxxxxxx>
---
 drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
index 0396084..3a37429 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
@@ -588,6 +588,7 @@ static void dpu_encoder_phys_vid_disable(struct dpu_encoder_phys *phys_enc)
 		}
 	}
 
+	dpu_encoder_helper_phys_cleanup(phys_enc);
 	phys_enc->enable_state = DPU_ENC_DISABLED;
 }
 
-- 
2.7.4




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux