The LLCC block has several banks each with a different base address
and holes in between. So it is not a correct approach to cover these
banks with a single offset/size. Instead, the individual bank's base
address needs to be specified in devicetree with the exact size.
On SDM845, the size of the LLCC bank 0 needs to be reduced to 0x4500 as
there are LLCC BWMON registers located after this range.
Reported-by: Parikshit Pareek <quic_ppareek@xxxxxxxxxxx>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sdm845.dtsi | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sdm845.dtsi b/arch/arm64/boot/dts/qcom/sdm845.dtsi
index 65032b94b46d..4db68d4d78df 100644
--- a/arch/arm64/boot/dts/qcom/sdm845.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm845.dtsi
@@ -2132,8 +2132,11 @@ uart15: serial@a9c000 {
llcc: system-cache-controller@1100000 {
compatible = "qcom,sdm845-llcc";
- reg = <0 0x01100000 0 0x31000>, <0 0x01300000 0 0x50000>;
- reg-names = "llcc_base", "llcc_broadcast_base";
+ reg = <0 0x01100000 0 0x45000>, <0 0x01180000 0 0x50000>,
+ <0 0x01200000 0 0x50000>, <0 0x01280000 0 0x50000>,
+ <0 0x01300000 0 0x50000>;
+ reg-names = "llcc0_base", "llcc1_base", "llcc2_base",
+ "llcc3_base", "llcc_broadcast_base";
interrupts = <GIC_SPI 582 IRQ_TYPE_LEVEL_HIGH>;
};
--
2.25.1
