Switch both power and performance clocks to the GPLL0/2 (sys_apcs_aux)
before PLL configuration. Switch them to the ACD afterwards.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
drivers/clk/qcom/clk-cpu-8996.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/clk/qcom/clk-cpu-8996.c b/drivers/clk/qcom/clk-cpu-8996.c
index 571ed52b3026..47c58bb5f21a 100644
--- a/drivers/clk/qcom/clk-cpu-8996.c
+++ b/drivers/clk/qcom/clk-cpu-8996.c
@@ -432,13 +432,27 @@ static int qcom_cpu_clk_msm8996_register_clks(struct device *dev,
{
int i, ret;
+ /* Select GPLL0 for 300MHz for the both clusters */
+ regmap_write(regmap, PERFCL_REG_OFFSET + MUX_OFFSET, 0xc);
+ regmap_write(regmap, PWRCL_REG_OFFSET + MUX_OFFSET, 0xc);
+
+ /* Ensure write goes through before PLLs are reconfigured */
+ udelay(5);
+
clk_alpha_pll_configure(&pwrcl_pll, regmap, &hfpll_config);
clk_alpha_pll_configure(&perfcl_pll, regmap, &hfpll_config);
clk_alpha_pll_configure(&pwrcl_alt_pll, regmap, &altpll_config);
clk_alpha_pll_configure(&perfcl_alt_pll, regmap, &altpll_config);
+ /* Wait for PLL(s) to lock */
+ udelay(50);
+
qcom_cpu_clk_msm8996_acd_init(regmap);
+ /* Switch clusters to use the ACD leg */
+ regmap_write(regmap, PWRCL_REG_OFFSET + MUX_OFFSET, 0x2);
+ regmap_write(regmap, PERFCL_REG_OFFSET + MUX_OFFSET, 0x2);
+
for (i = 0; i < ARRAY_SIZE(cpu_msm8996_hw_clks); i++) {
ret = devm_clk_hw_register(dev, cpu_msm8996_hw_clks[i]);
if (ret)
--
2.30.2
