Currently, a RCG's M/N counter (used for fraction division) is set to either 'bypass' (counter disabled) or 'dual edge' (counter enabled) based on whether the corresponding rcg struct has a mnd field specified and a non-zero N. In the case where M and N are the same value, the M/N counter is still enabled by code even though no division takes place. Leaving the RCG in such a state can result in improper behavior. This was observed with the DSI pixel clock RCG when M and N were both set to 1. Add an additional check (M != N) to enable the M/N counter only when it's needed for fraction division. Signed-off-by: Archit Taneja <architt@xxxxxxxxxxxxxx> --- drivers/clk/qcom/clk-rcg2.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c index 08b8b37..4fe9c01 100644 --- a/drivers/clk/qcom/clk-rcg2.c +++ b/drivers/clk/qcom/clk-rcg2.c @@ -242,7 +242,7 @@ static int clk_rcg2_configure(struct clk_rcg2 *rcg, const struct freq_tbl *f) mask |= CFG_SRC_SEL_MASK | CFG_MODE_MASK; cfg = f->pre_div << CFG_SRC_DIV_SHIFT; cfg |= rcg->parent_map[f->src] << CFG_SRC_SEL_SHIFT; - if (rcg->mnd_width && f->n) + if (rcg->mnd_width && f->n && (f->m != f->n)) cfg |= CFG_MODE_DUAL_EDGE; ret = regmap_update_bits(rcg->clkr.regmap, rcg->cmd_rcgr + CFG_REG, mask, cfg); -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html