On 31/12/2022 23:24, Lux Aliaga wrote:
> Adds a UFS host controller node and its corresponding PHY to
> the sm6125 platform.
>
> Signed-off-by: Lux Aliaga <they@xxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/sm6125.dtsi | 59 ++++++++++++++++++++++++++++
> 1 file changed, 59 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sm6125.dtsi b/arch/arm64/boot/dts/qcom/sm6125.dtsi
> index df5453fcf2b9..9cb081332849 100644
> --- a/arch/arm64/boot/dts/qcom/sm6125.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sm6125.dtsi
> @@ -511,6 +511,65 @@ sdhc_2: mmc@4784000 {
> status = "disabled";
> };
>
> + ufs_mem_hc: ufs@4804000 {
> + compatible = "qcom,sm6125-ufshc", "qcom,ufshc", "jedec,ufs-2.0";
> + reg = <0x04804000 0x3000>, <0x04810000 0x8000>;
> + reg-names = "std", "ice";
> + interrupts = <GIC_SPI 356 IRQ_TYPE_LEVEL_HIGH>;
> + phys = <&ufs_mem_phy>;
> + phy-names = "ufsphy";
> + lanes-per-direction = <1>;
> + #reset-cells = <1>;
> + resets = <&gcc GCC_UFS_PHY_BCR>;
> + reset-names = "rst";
> + iommus = <&apps_smmu 0x200 0x0>;
> +
> + clock-names = "core_clk",
> + "bus_aggr_clk",
> + "iface_clk",
> + "core_clk_unipro",
> + "ref_clk",
> + "tx_lane0_sync_clk",
> + "rx_lane0_sync_clk",
> + "ice_core_clk";
> + clocks = <&gcc GCC_UFS_PHY_AXI_CLK>,
> + <&gcc GCC_SYS_NOC_UFS_PHY_AXI_CLK>,
> + <&gcc GCC_UFS_PHY_AHB_CLK>,
> + <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>,
> + <&rpmcc RPM_SMD_XO_CLK_SRC>,
> + <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
> + <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>,
> + <&gcc GCC_UFS_PHY_ICE_CORE_CLK>;
> + freq-table-hz = <50000000 240000000>,
> + <0 0>,
> + <0 0>,
> + <37500000 150000000>,
> + <0 0>,
> + <0 0>,
> + <0 0>,
> + <75000000 300000000>;
> +
> + non-removable;
Does not look like you tested the bindings. Please run `make
dt_binding_check` (see
Documentation/devicetree/bindings/writing-schema.rst for instructions).
Best regards,
Krzysztof
