From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
We don't stop transmissions in progress at shutdown. This is fine with
FIFO SE mode but with DMA (support for which we'll introduce later) it
causes trouble so fix it now.
Fixes: e83766334f96 ("tty: serial: qcom_geni_serial: No need to stop tx/rx on UART shutdown")
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index b487823f0e61..4f4c12f3c433 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -880,6 +880,8 @@ static void get_tx_fifo_size(struct qcom_geni_serial_port *port)
static void qcom_geni_serial_shutdown(struct uart_port *uport)
{
disable_irq(uport->irq);
+ qcom_geni_serial_stop_tx(uport);
+ qcom_geni_serial_stop_rx(uport);
}
static int qcom_geni_serial_port_setup(struct uart_port *uport)
--
2.37.2
