On Wed, Dec 14, 2022 at 09:06:48PM +0530, Shazad Hussain wrote:
> > i2c0_default: i2c0-default-state {
> > pins = "gpio135", "gpio136";
> > function = "qup15";
> > drive-strength = <2>;
> > bias-pull-up;
> > };
> >
>
> This is the default config we should use.
OK, I'll stick with this config.
> > Shazad: 'i2cdetect -a -y $BUSNUM) shows that all 5 buses have the same
> > addresses listening. Is that expected? That seems a bit odd to me.
> >
>
> Brian, even I haven't checked with all enabled, let me check this on other
> projects and with downstream as well and get back to you.
I'll post my v2 in a little bit so that you can test it.
Brian
