On 02/12/2022 15:36, Doug Anderson wrote:
> Hi,
>
> On Fri, Dec 2, 2022 at 12:15 AM Krzysztof Kozlowski
> <krzysztof.kozlowski@xxxxxxxxxx> wrote:
>>
>>>> qup_uart6_4pin: qup-uart6-4pin-state {
>>>> -
>>>> - cts-pins {
>>>> + qup_uart6_4pin_cts: cts-pins {
>>>> pins = "gpio45";
>>>> function = "qup6";
>>>> - bias-pull-down;
>>>
>>> After your patch, where is the above bias set for cheza, db845c,
>>> oneplus, shift-axolotl, ...?
>>>
>>>
>>>> };
>>>>
>>>> - rts-tx-pins {
>>>> + qup_uart6_4pin_rts_tx: rts-tx-pins {
>>>> pins = "gpio46", "gpio47";
>>>> function = "qup6";
>>>> - drive-strength = <2>;
>>>> - bias-disable;
>>>
>>> After your patch, where is the above bias / drive-strength set?
>>
>> They don't use 4-pin setup. If they use, I would assume they will
>> override the entries just like sdm850 boards (where I override it to set
>> these).
>>
>> Alternatively I can keep it in DTSI, but it is not really property of
>> the SoC.
>
> I see things like:
>
> .../sdm845-cheza.dtsi: pinctrl-0 = <&qup_uart6_4pin>;
>
> ...before your patch that would get the bias/drive strength from the
> SoC dtsi, right? After your patch, you've removed it from the dtsi but
> not added it to the board. ...so I think it's a net change. Did I mess
> up / miss something?
I missed something or rather my git grep failed. I'll bring them back to
DTSI.
Best regards,
Krzysztof
