From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
We don't stop transmissions in progress at shutdown. This is fine with
FIFO SE mode but with DMA it causes trouble so fix it now.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 808b0250d51e..1dfc0122ff53 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -864,6 +864,8 @@ static void get_tx_fifo_size(struct qcom_geni_serial_port *port)
static void qcom_geni_serial_shutdown(struct uart_port *uport)
{
disable_irq(uport->irq);
+ qcom_geni_serial_stop_tx(uport);
+ qcom_geni_serial_stop_rx(uport);
}
static int qcom_geni_serial_port_setup(struct uart_port *uport)
--
2.37.2
