From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
The following symbols will be used when adding support for SE DMA in
the qcom geni serial driver.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
---
include/linux/qcom-geni-se.h | 3 +++
1 file changed, 3 insertions(+)
diff --git a/include/linux/qcom-geni-se.h b/include/linux/qcom-geni-se.h
index f5672785c0c4..400213daa461 100644
--- a/include/linux/qcom-geni-se.h
+++ b/include/linux/qcom-geni-se.h
@@ -103,6 +103,7 @@ struct geni_se {
#define SE_DMA_TX_FSM_RST 0xc58
#define SE_DMA_RX_IRQ_STAT 0xd40
#define SE_DMA_RX_IRQ_CLR 0xd44
+#define SE_DMA_RX_LEN_IN 0xd54
#define SE_DMA_RX_FSM_RST 0xd58
#define SE_HW_PARAM_0 0xe24
#define SE_HW_PARAM_1 0xe28
@@ -235,6 +236,8 @@ struct geni_se {
#define RX_SBE BIT(2)
#define RX_RESET_DONE BIT(3)
#define RX_FLUSH_DONE BIT(4)
+#define RX_DMA_PARITY_ERR BIT(5)
+#define RX_DMA_BREAK GENMASK(8, 7)
#define RX_GENI_GP_IRQ GENMASK(10, 5)
#define RX_GENI_CANCEL_IRQ BIT(11)
#define RX_GENI_GP_IRQ_EXT GENMASK(13, 12)
--
2.37.2
