On 16/11/2022 11:31, Abel Vesa wrote:
> From: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
>
> Add nodes for pm8010 in separate dtsi file.
>
> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/pm8010.dtsi | 84 ++++++++++++++++++++++++++++
> 1 file changed, 84 insertions(+)
> create mode 100644 arch/arm64/boot/dts/qcom/pm8010.dtsi
>
> diff --git a/arch/arm64/boot/dts/qcom/pm8010.dtsi b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> new file mode 100644
> index 000000000000..0ea641e12209
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> @@ -0,0 +1,84 @@
> +// SPDX-License-Identifier: BSD-3-Clause
Any reason why this is licensed BSD-3 clause? It's not a recommended
license (2 clause is). Same for other patches.
> +/*
> + * Copyright (c) 2022, Linaro Limited
> + */
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +/ {
> + thermal-zones {
> + pm8010-m-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> +
> + thermal-sensors = <&pm8010_m_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "hot";
> + };
> + };
> + };
> +
> + pm8010-n-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> +
> + thermal-sensors = <&pm8010_n_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "hot";
> + };
> + };
> + };
> + };
> +};
> +
> +
Just one blank line.
Best regards,
Krzysztof
