Add the pin setup for SPI/I2C configurations that are supported
downstream. I can guesstimate the correct settings for other buses,
but:
- I have no hardware to test it on
- Some QUPs are straight up missing pin funcs in TLMM
- Vendors probably didn't really care and used whatever was there in
the reference design and BSP - should any other be used, they can be
configured at a later time
Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm6375.dtsi | 43 ++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sm6375.dtsi b/arch/arm64/boot/dts/qcom/sm6375.dtsi
index 62a64dd731a0..952156891476 100644
--- a/arch/arm64/boot/dts/qcom/sm6375.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm6375.dtsi
@@ -519,6 +519,49 @@ tlmm: pinctrl@500000 {
gpio-controller;
#interrupt-cells = <2>;
#gpio-cells = <2>;
+
+ qup_i2c0_default: qup-i2c0-default-state {
+ pins = "gpio0", "gpio1";
+ function = "qup00";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ qup_i2c1_default: qup-i2c1-default-state {
+ pins = "gpio61", "gpio62";
+ function = "qup01";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ qup_i2c2_default: qup-i2c2-default-state {
+ pins = "gpio45", "gpio46";
+ function = "qup02";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ qup_i2c8_default: qup-i2c8-default-state {
+ pins = "gpio19", "gpio20";
+ /* TLMM, GCC and vendor DT all have different indices.. */
+ function = "qup12";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ qup_i2c10_default: qup-i2c10-default-state {
+ pins = "gpio4", "gpio5";
+ function = "qup10";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ qup_spi0_default: qup-spi0-default-state {
+ pins = "gpio0", "gpio1", "gpio2", "gpio3";
+ function = "qup00";
+ drive-strength = <6>;
+ bias-disable;
+ };
};
gcc: clock-controller@1400000 {
--
2.38.1
