The common Qualcomm TLMM pin controller schema for pin mux and config already brings requirement of function for gpio pins and the definition of drive-strength. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> Acked-by: Rob Herring <robh@xxxxxxxxxx> --- Changes since v2: 1. Drop drive-strength, reword commit msg. 2. Add tags. 3. This was previously part of: https://lore.kernel.org/linux-arm-msm/20221011172358.69043-1-krzysztof.kozlowski@xxxxxxxxxx/T/#m277d25a5f3e9d10ca8221a7fba62ca468a67a60b --- .../bindings/pinctrl/qcom,sc7280-pinctrl.yaml | 18 ++---------------- 1 file changed, 2 insertions(+), 16 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml index 2a6b5a719d18..d70ab12f227d 100644 --- a/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml +++ b/Documentation/devicetree/bindings/pinctrl/qcom,sc7280-pinctrl.yaml @@ -62,6 +62,7 @@ $defs: description: Pinctrl node's client devices use subnodes for desired pin configuration. Client device subnodes use below standard properties. + $ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state properties: pins: @@ -110,16 +111,11 @@ $defs: uim1_clk, uim1_data, uim1_present, uim1_reset, usb2phy_ac, usb_phy, vfr_0, vfr_1, vsense_trigger ] - drive-strength: - enum: [2, 4, 6, 8, 10, 12, 14, 16] - default: 2 - description: - Selects the drive strength for the specified pins, in mA. - bias-pull-down: true bias-pull-up: true bias-bus-hold: true bias-disable: true + drive-strength: true input-enable: true output-high: true output-low: true @@ -127,16 +123,6 @@ $defs: required: - pins - allOf: - - $ref: /schemas/pinctrl/pincfg-node.yaml - - if: - properties: - pins: - pattern: "^gpio([0-9]|[1-9][0-9]|1[0-6][0-9]|17[0-4])$" - then: - required: - - function - additionalProperties: false allOf: -- 2.34.1
