Re: [PATCH 13/13] phy: qcom-qmp-usb: drop power-down delay config

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 11/10/2022 16:14, Johan Hovold wrote:
The power-down delay was included in the first version of the QMP driver
as an optional delay after powering on the PHY (using
POWER_DOWN_CONTROL) and just before starting it. Later changes modified
this sequence by powering on before initialising the PHY, but the
optional delay stayed where it was (i.e. before starting the PHY).

The vendor driver does not use a delay before starting the PHY and this
is likely not needed on any platform unless there is a corresponding
delay in the vendor kernel init sequence tables (i.e. in devicetree).

Let's keep the delay for now, but drop the redundant delay period
configuration while increasing the unnecessarily low timer slack
somewhat.

Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
---
  drivers/phy/qualcomm/phy-qcom-qmp-usb.c | 35 +------------------------
  1 file changed, 1 insertion(+), 34 deletions(-)

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

--
With best wishes
Dmitry




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux