There are no need to add additional simple-bus nodes just to populate
a single pwrseq device. Pull it up one level into /. While we are at it
also fix node name replacing underscore with dash.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom-apq8064-ifc6410.dts | 18 +++++++-----------
1 file changed, 7 insertions(+), 11 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
index 610fb8d652c3..96307550523a 100644
--- a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
@@ -22,17 +22,6 @@ chosen {
stdout-path = "serial0:115200n8";
};
- pwrseq {
- compatible = "simple-bus";
-
- sdcc4_pwrseq: sdcc4_pwrseq {
- pinctrl-names = "default";
- pinctrl-0 = <&wlan_default_gpios>;
- compatible = "mmc-pwrseq-simple";
- reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
- };
- };
-
leds {
compatible = "gpio-leds";
pinctrl-names = "default";
@@ -57,6 +46,13 @@ hdmi_con: endpoint {
};
};
+ sdcc4_pwrseq: pwrseq-sdcc4 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wlan_default_gpios>;
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
+ };
+
ext_3p3v: regulator-ext-3p3v {
compatible = "regulator-fixed";
regulator-min-microvolt = <3300000>;
--
2.35.1
