Hi Jack,
On Dienstag, 23. November 2021 00:52:30 CEST Jack Matthews wrote:
> Add PON node with pwrkey and resin as child nodes.
> Also adds resin, and additional properties to pwrkey.
I just saw that this patch hasn't been applied yet.
As it doesn't apply cleanly anymore can you please rebase it and send a v2?
Hopefully Bjorn can apply it then :)
Regards
Luca
>
> Signed-off-by: Jack Matthews <jm5112356@xxxxxxxxx>
> ---
> arch/arm/boot/dts/qcom-pm8226.dtsi | 27 +++++++++++++++++++++------
> 1 file changed, 21 insertions(+), 6 deletions(-)
>
> diff --git a/arch/arm/boot/dts/qcom-pm8226.dtsi
> b/arch/arm/boot/dts/qcom-pm8226.dtsi index 666bc6350c50..63f3026c25bf
> 100644
> --- a/arch/arm/boot/dts/qcom-pm8226.dtsi
> +++ b/arch/arm/boot/dts/qcom-pm8226.dtsi
> @@ -1,5 +1,6 @@
> // SPDX-License-Identifier: BSD-3-Clause
> #include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/input/input.h>
> #include <dt-bindings/spmi/spmi.h>
>
> &spmi_bus {
> @@ -9,12 +10,26 @@ pm8226_0: pm8226@0 {
> #address-cells = <1>;
> #size-cells = <0>;
>
> - pwrkey@800 {
> - compatible = "qcom,pm8941-pwrkey";
> - reg = <0x800>;
> - interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
> - debounce = <15625>;
> - bias-pull-up;
> + pon: power-on@800 {
> + compatible = "qcom,pm8916-pon";
> + reg = <0x0800>;
> +
> + pm8226_pwrkey: pwrkey {
> + compatible = "qcom,pm8941-
pwrkey";
> + interrupts = <0x0 0x8 0
IRQ_TYPE_EDGE_BOTH>;
> + debounce = <15625>;
> + bias-pull-up;
> + linux,code = <KEY_POWER>;
> + };
> +
> + pm8226_resin: resin {
> + compatible = "qcom,pm8941-resin";
> + interrupts = <0x0 0x8 1
IRQ_TYPE_EDGE_BOTH>;
> + debounce = <15625>;
> + bias-pull-up;
> +
> + status = "disabled";
> + };
> };
>
> smbb: charger@1000 {
