When BLSPI1 (originally SPI0, later renamed in commit f82c48d46852
("arm64: dts: qcom: ipq6018: correct QUP peripheral labels")) was added,
the device node lacked respective pin configuration assignment. It
used also blsp0_spi function but that was probably the same mistake as
naming it SPI0.
Fixes: 5bf635621245 ("arm64: dts: ipq6018: Add a few device nodes")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts b/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
index 1ba2eca33c7b..afc2dc79767d 100644
--- a/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
+++ b/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
@@ -37,6 +37,8 @@ &blsp1_i2c3 {
&blsp1_spi1 {
cs-select = <0>;
+ pinctrl-0 = <&spi_0_pins>;
+ pinctrl-names = "default";
status = "okay";
flash@0 {
@@ -57,7 +59,7 @@ i2c_1_pins: i2c-1-pins {
spi_0_pins: spi-0-pins {
pins = "gpio38", "gpio39", "gpio40", "gpio41";
- function = "blsp0_spi";
+ function = "blsp1_spi";
drive-strength = <8>;
bias-pull-down;
};
--
2.34.1
