On Friday 07 November 2014 13:35:45 Frank Rowand wrote: > On 11/7/2014 1:47 AM, Arnd Bergmann wrote: > > On Thursday 06 November 2014 22:42:47 Frank Rowand wrote: > >> This same change is also needed in: > >> > >> qcom-ipq8064.dtsi > >> qcom-msm8960.dtsi > >> qcom-apq8084.dtsi > >> qcom-apq8064.dtsi > >> qcom-msm8660.dtsi > >> > >> but I did not want to just blindly apply those changes without testing. > >> > > > > Is there only one uart on each of these? > > > > If not, it would be better to put the aliases in the board specific file, > > pointing to whichever ports are in use, in the order that makes sense > > for that board. > > Good point, thanks for bringing it up. > > Your comment made me verify that the board dts files can override the > aliases from the included .dtsi. So not a problem to have a default > set of aliases in the .dtsi files. I would think it's better to keep them in the per-board file out of principle though. Arnd -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html