[PATCH 31/40] dt-bindings: pinctrl: qcom,sc8280xp-pinctrl: fix matching pin config

[Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>]

Matching PMIC GPIOs config nodes within a '-state' node by '.*' pattern
does not work as expected because of linux,phandle in the DTB:

    'pins' is a required property
    'function' is a required property
    'rx', 'tx' do not match any of the regexes: 'pinctrl-[0-9]+'
    [[59]] is not of type 'object'

Make the schema stricter and expect such nodes to be either named
'pinconfig' or followed with '-pins' prefix.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 .../devicetree/bindings/pinctrl/qcom,sc8280xp-pinctrl.yaml | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-pinctrl.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-pinctrl.yaml
index 87a381c9a19d..5147afc28721 100644
--- a/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-pinctrl.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-pinctrl.yaml
@@ -43,8 +43,9 @@ patternProperties:
     oneOf:
       - $ref: "#/$defs/qcom-sc8280xp-tlmm-state"
       - patternProperties:
-          ".*":
+          "-pins$":
             $ref: "#/$defs/qcom-sc8280xp-tlmm-state"
+        additionalProperties: false
 
 '$defs':
   qcom-sc8280xp-tlmm-state:
@@ -135,13 +136,13 @@ examples:
                 };
 
                 uart-w-subnodes-state {
-                        rx {
+                        rx-pins {
                                 pins = "gpio4";
                                 function = "qup14";
                                 bias-pull-up;
                         };
 
-                        tx {
+                        tx-pins {
                                 pins = "gpio5";
                                 function = "qup14";
                                 bias-disable;
-- 
2.34.1