On 10/08/2022 23:33, Dmitry Torokhov wrote:
> Hi Caleb,
>
> On Mon, May 16, 2022 at 02:22:57PM +0000, Caleb Connolly wrote:
>> Add SW_PROG{1,2,3,4} for device switches which are handled by userspace.
>>
>> This can be used for devices with "generic" switches which are intended
>> to be user-programmable, for example OnePlus phones contain a tri-state
>> key which can be used for switching between mute/vibrate/ring, or
>> programmed by the user to perform any arbitrary actions.
>>
>> These are analogous to the keys KEY_PROG{1,2,3,4} found on some
>> keyboards.
Hi Dmitry,
>
> This has been proposed a few times but this goes against the spirit of
> the input subsystem where each key or switch has a defined [default]
> purpose and userspace is normally expected to act upon input events
> without paying attention to what device they actually are coming from.
> IOW if you want to deal with particular GPIO signals you are better off
> using GPIO subsystem.
>
> In this context adding KEY_PROG1-4 was actually a mistake and we should
> try not extend it further.
>
> As fas as modeling the sliders with multiple settings goes I'd look into
> ABS events, probably ABS_MISC, with a set of values.
Ah I wasn't aware of ABS_MISC, this looks like a good way to go. Thanks.
>
> Thanks.
>
> --
> Dmitry
--
Kind Regards,
Caleb
