Using node paths to extend or override a device tree node is error
prone. If there was a typo error, a new node will be created instead of
extending the existing node. This will lead to run-time errors that
could be hard to detect.
A mistyped label on the other hand, will cause a dtc compile error
(during build time). This also reduces the indentation making the code
easier to read.
The pre/post DTBS are the same.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom-msm8660-surf.dts | 41 ++++++++++++-------------
1 file changed, 20 insertions(+), 21 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-msm8660-surf.dts b/arch/arm/boot/dts/qcom-msm8660-surf.dts
index 414280d9bdba..63b8f4285ace 100644
--- a/arch/arm/boot/dts/qcom-msm8660-surf.dts
+++ b/arch/arm/boot/dts/qcom-msm8660-surf.dts
@@ -16,14 +16,6 @@ chosen {
};
soc {
- gsbi@19c00000 {
- status = "okay";
- qcom,mode = <GSBI_PROT_I2C_UART>;
- serial@19c40000 {
- status = "okay";
- };
- };
-
/* Temporary fixed regulator */
vsdcc_fixed: vsdcc-regulator {
compatible = "regulator-fixed";
@@ -32,21 +24,16 @@ vsdcc_fixed: vsdcc-regulator {
regulator-max-microvolt = <2700000>;
regulator-always-on;
};
+ };
+};
- amba {
- /* eMMC */
- sdcc1: mmc@12400000 {
- status = "okay";
- vmmc-supply = <&vsdcc_fixed>;
- };
+&gsbi12 {
+ qcom,mode = <GSBI_PROT_I2C_UART>;
+ status = "okay";
+};
- /* External micro SD card */
- sdcc3: mmc@12180000 {
- status = "okay";
- vmmc-supply = <&vsdcc_fixed>;
- };
- };
- };
+&gsbi12_serial {
+ status = "okay";
};
&pm8058 {
@@ -76,3 +63,15 @@ MATRIX_KEY(5, 4, KEY_MENU)
keypad,num-columns = <5>;
};
};
+
+/* eMMC */
+&sdcc1 {
+ vmmc-supply = <&vsdcc_fixed>;
+ status = "okay";
+};
+
+/* External micro SD card */
+&sdcc3 {
+ vmmc-supply = <&vsdcc_fixed>;
+ status = "okay";
+};
--
2.34.1
