The eDP phy can be used to drive either eDP or DP output, with some
minor variations in some of the configuration and seemingly a need for
implementing swing and pre_emphasis calibration.
Introduce a config object, indicating if the phy is operating in eDP or
DP mode and swing/pre-emphasis calibration to support this.
Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
---
drivers/phy/qualcomm/phy-qcom-edp.c | 80 +++++++++++++++++++++++++++--
1 file changed, 76 insertions(+), 4 deletions(-)
diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
index 32614fb838b5..301ac422d2fe 100644
--- a/drivers/phy/qualcomm/phy-qcom-edp.c
+++ b/drivers/phy/qualcomm/phy-qcom-edp.c
@@ -70,8 +70,19 @@
#define TXn_TRAN_DRVR_EMP_EN 0x0078
+struct qcom_edp_cfg {
+ bool is_dp;
+
+ /* DP PHY swing and pre_emphasis tables */
+ const u8 (*swing_hbr_rbr)[4][4];
+ const u8 (*swing_hbr3_hbr2)[4][4];
+ const u8 (*pre_emphasis_hbr_rbr)[4][4];
+ const u8 (*pre_emphasis_hbr3_hbr2)[4][4];
+};
+
struct qcom_edp {
struct device *dev;
+ const struct qcom_edp_cfg *cfg;
struct phy *phy;
@@ -92,7 +103,9 @@ struct qcom_edp {
static int qcom_edp_phy_init(struct phy *phy)
{
struct qcom_edp *edp = phy_get_drvdata(phy);
+ const struct qcom_edp_cfg *cfg = edp->cfg;
int ret;
+ u8 cfg8;
ret = regulator_bulk_enable(ARRAY_SIZE(edp->supplies), edp->supplies);
if (ret)
@@ -117,6 +130,13 @@ static int qcom_edp_phy_init(struct phy *phy)
DP_PHY_PD_CTL_PLL_PWRDN | DP_PHY_PD_CTL_DP_CLAMP_EN,
edp->edp + DP_PHY_PD_CTL);
+ if (cfg && cfg->is_dp)
+ cfg8 = 0xb7;
+ else
+ cfg8 = 0x37;
+
+ writel(0xfc, edp->edp + DP_PHY_MODE);
+
writel(0x00, edp->edp + DP_PHY_AUX_CFG0);
writel(0x13, edp->edp + DP_PHY_AUX_CFG1);
writel(0x24, edp->edp + DP_PHY_AUX_CFG2);
@@ -125,7 +145,7 @@ static int qcom_edp_phy_init(struct phy *phy)
writel(0x26, edp->edp + DP_PHY_AUX_CFG5);
writel(0x0a, edp->edp + DP_PHY_AUX_CFG6);
writel(0x03, edp->edp + DP_PHY_AUX_CFG7);
- writel(0x37, edp->edp + DP_PHY_AUX_CFG8);
+ writel(cfg8, edp->edp + DP_PHY_AUX_CFG8);
writel(0x03, edp->edp + DP_PHY_AUX_CFG9);
writel(PHY_AUX_STOP_ERR_MASK | PHY_AUX_DEC_ERR_MASK |
@@ -142,14 +162,60 @@ static int qcom_edp_phy_init(struct phy *phy)
return ret;
}
+static int qcom_edp_set_voltages(struct qcom_edp *edp, const struct phy_configure_opts_dp *dp_opts)
+{
+ const struct qcom_edp_cfg *cfg = edp->cfg;
+ unsigned int v_level = 0;
+ unsigned int p_level = 0;
+ u8 ldo_config;
+ u8 swing;
+ u8 emph;
+ int i;
+
+ if (!cfg)
+ return 0;
+
+ for (i = 0; i < dp_opts->lanes; i++) {
+ v_level = max(v_level, dp_opts->voltage[i]);
+ p_level = max(p_level, dp_opts->pre[i]);
+ }
+
+ if (dp_opts->link_rate <= 2700) {
+ swing = (*cfg->swing_hbr_rbr)[v_level][p_level];
+ emph = (*cfg->pre_emphasis_hbr_rbr)[v_level][p_level];
+ } else {
+ swing = (*cfg->swing_hbr3_hbr2)[v_level][p_level];
+ emph = (*cfg->pre_emphasis_hbr3_hbr2)[v_level][p_level];
+ }
+
+ if (swing == 0xff || emph == 0xff)
+ return -EINVAL;
+
+ ldo_config = (cfg && cfg->is_dp) ? 0x1 : 0x0;
+
+ writel(ldo_config, edp->tx0 + TXn_LDO_CONFIG);
+ writel(swing, edp->tx0 + TXn_TX_DRV_LVL);
+ writel(emph, edp->tx0 + TXn_TX_EMP_POST1_LVL);
+
+ writel(ldo_config, edp->tx1 + TXn_LDO_CONFIG);
+ writel(swing, edp->tx1 + TXn_TX_DRV_LVL);
+ writel(emph, edp->tx1 + TXn_TX_EMP_POST1_LVL);
+
+ return 0;
+}
+
static int qcom_edp_phy_configure(struct phy *phy, union phy_configure_opts *opts)
{
const struct phy_configure_opts_dp *dp_opts = &opts->dp;
struct qcom_edp *edp = phy_get_drvdata(phy);
+ int ret = 0;
memcpy(&edp->dp_opts, dp_opts, sizeof(*dp_opts));
- return 0;
+ if (dp_opts->set_voltages)
+ ret = qcom_edp_set_voltages(edp, dp_opts);
+
+ return ret;
}
static int qcom_edp_configure_ssc(const struct qcom_edp *edp)
@@ -315,7 +381,9 @@ static int qcom_edp_set_vco_div(const struct qcom_edp *edp)
static int qcom_edp_phy_power_on(struct phy *phy)
{
const struct qcom_edp *edp = phy_get_drvdata(phy);
+ const struct qcom_edp_cfg *cfg = edp->cfg;
u32 bias0_en, drvr0_en, bias1_en, drvr1_en;
+ u8 ldo_config;
int timeout;
int ret;
u32 val;
@@ -332,8 +400,11 @@ static int qcom_edp_phy_power_on(struct phy *phy)
if (timeout)
return timeout;
- writel(0x01, edp->tx0 + TXn_LDO_CONFIG);
- writel(0x01, edp->tx1 + TXn_LDO_CONFIG);
+
+ ldo_config = (cfg && cfg->is_dp) ? 0x1 : 0x0;
+
+ writel(ldo_config, edp->tx0 + TXn_LDO_CONFIG);
+ writel(ldo_config, edp->tx1 + TXn_LDO_CONFIG);
writel(0x00, edp->tx0 + TXn_LANE_MODE_1);
writel(0x00, edp->tx1 + TXn_LANE_MODE_1);
@@ -635,6 +706,7 @@ static int qcom_edp_phy_probe(struct platform_device *pdev)
return -ENOMEM;
edp->dev = dev;
+ edp->cfg = of_device_get_match_data(&pdev->dev);
edp->edp = devm_platform_ioremap_resource(pdev, 0);
if (IS_ERR(edp->edp))
--
2.35.1
