When we multiply an unsigned int by a u32 we still end up with an
unsigned int. That means we should specify "%u" not "%lu" in the
format code.
NOTE: this fix was chosen instead of somehow promoting the value to
"unsigned long" since the max baud rate from the earlier call to
uart_get_baud_rate() is 4000000 and the max sampling rate is 32.
4000000 * 32 = 0x07a12000, not even close to overflowing 32-bits.
Fixes: c474c775716e ("tty: serial: qcom-geni-serial: Fix get_clk_div_rate() which otherwise could return a sub-optimal clock rate.")
Reported-by: Mark Brown <broonie@xxxxxxxxxx>
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index f754619451dc..f7c1f1807040 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -1033,12 +1033,12 @@ static void qcom_geni_serial_set_termios(struct uart_port *uport,
sampling_rate, &clk_div);
if (!clk_rate) {
dev_err(port->se.dev,
- "Couldn't find suitable clock rate for %lu\n",
+ "Couldn't find suitable clock rate for %u\n",
baud * sampling_rate);
goto out_restart_rx;
}
- dev_dbg(port->se.dev, "desired_rate-%lu, clk_rate-%lu, clk_div-%u\n",
+ dev_dbg(port->se.dev, "desired_rate-%u, clk_rate-%lu, clk_div-%u\n",
baud * sampling_rate, clk_rate, clk_div);
uport->uartclk = clk_rate;
--
2.37.1.455.g008518b4e5-goog
