Use the same USB definition as qcom-apq8064.dtsi, tested on Casio GzOne. Signed-off-by: Shinjo Park <peremen@xxxxxxxxx> Reviewed-by: David Heidelberg <david@xxxxxxx> --- arch/arm/boot/dts/qcom-msm8960.dtsi | 32 +++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+) diff --git a/arch/arm/boot/dts/qcom-msm8960.dtsi b/arch/arm/boot/dts/qcom-msm8960.dtsi index 991eb1948..a32073d61 100644 --- a/arch/arm/boot/dts/qcom-msm8960.dtsi +++ b/arch/arm/boot/dts/qcom-msm8960.dtsi @@ -4,6 +4,7 @@ #include <dt-bindings/interrupt-controller/arm-gic.h> #include <dt-bindings/clock/qcom,gcc-msm8960.h> #include <dt-bindings/clock/qcom,lcc-msm8960.h> +#include <dt-bindings/reset/qcom,gcc-msm8960.h> #include <dt-bindings/mfd/qcom-rpm.h> #include <dt-bindings/soc/qcom,gsbi.h> @@ -201,6 +202,37 @@ regulators { }; }; + usb1: usb@12500000 { + compatible = "qcom,ci-hdrc"; + reg = <0x12500000 0x200>, + <0x12500200 0x200>; + interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&gcc USB_HS1_XCVR_CLK>, <&gcc USB_HS1_H_CLK>; + clock-names = "core", "iface"; + assigned-clocks = <&gcc USB_HS1_XCVR_CLK>; + assigned-clock-rates = <60000000>; + resets = <&gcc USB_HS1_RESET>; + reset-names = "core"; + phy_type = "ulpi"; + ahb-burst-config = <0>; + phys = <&usb_hs1_phy>; + phy-names = "usb-phy"; + status = "disabled"; + #reset-cells = <1>; + + ulpi { + usb_hs1_phy: phy { + compatible = "qcom,usb-hs-phy-msm8960", + "qcom,usb-hs-phy"; + clocks = <&sleep_clk>, <&cxo_board>; + clock-names = "sleep", "ref"; + resets = <&usb1 0>; + reset-names = "por"; + #phy-cells = <0>; + }; + }; + }; + acc0: clock-controller@2088000 { compatible = "qcom,kpss-acc-v1"; reg = <0x02088000 0x1000>, <0x02008000 0x1000>; -- 2.34.1