On Sun, Jul 10, 2022 at 12:00:40PM +0300, Dmitry Baryshkov wrote: > Move properties common to all DPU DT nodes to the dpu-common.yaml. > > Note, this removes description of individual DPU port@ nodes. However > such definitions add no additional value. The reg values do not > correspond to hardware INTF indices. The driver discovers and binds > these ports not paying any care for the order of these items. Thus just > leave the reference to graph.yaml#/properties/ports and the description. > > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> > --- > .../bindings/display/msm/dpu-common.yaml | 42 ++++++++++++++++++ > .../bindings/display/msm/dpu-msm8998.yaml | 43 ++----------------- > .../bindings/display/msm/dpu-qcm2290.yaml | 39 ++--------------- > .../bindings/display/msm/dpu-sc7180.yaml | 43 ++----------------- > .../bindings/display/msm/dpu-sc7280.yaml | 43 ++----------------- > .../bindings/display/msm/dpu-sdm845.yaml | 43 ++----------------- > 6 files changed, 62 insertions(+), 191 deletions(-) > create mode 100644 Documentation/devicetree/bindings/display/msm/dpu-common.yaml > > diff --git a/Documentation/devicetree/bindings/display/msm/dpu-common.yaml b/Documentation/devicetree/bindings/display/msm/dpu-common.yaml > new file mode 100644 > index 000000000000..14eda883e149 > --- /dev/null > +++ b/Documentation/devicetree/bindings/display/msm/dpu-common.yaml > @@ -0,0 +1,42 @@ > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/display/msm/dpu-common.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Qualcomm Display DPU dt properties (common properties) > + > +maintainers: > + - Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> > + - Krishna Manikandan <quic_mkrishn@xxxxxxxxxxx> > + - Rob Clark <robdclark@xxxxxxxxx> > + > +description: | > + Common properties for QCom DPU display controller. > + > +properties: > + interrupts: > + maxItems: 1 > + > + power-domains: > + maxItems: 1 > + > + operating-points-v2: true > + > + ports: > + $ref: /schemas/graph.yaml#/properties/ports > + description: | > + Contains the list of output ports from DPU device. These ports > + connect to interfaces that are external to the DPU hardware, > + such as DSI, DP etc. >From the last version: > In case of MDSS all ports are output, they are connected to the external > interfaces (DSI, DP, HDMI, etc). The driver uses them to bind available > interfaces (using components framework). The reg property of the port is > completely ignored. It doesn't matter what the driver does or doesn't do. Without describing port nodes at all, you are not validating what port nodes can contain. Just try adding any property under a port node. You need at least: '^port@[0-N]$': $ref: graph.yaml#/properties/port where N is the max number of ports. Rob
