[PATCH 0/5] clk: qcom: Drop use of pxo/cxo_board for rpm devices

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Trying to convert every driver used by ipq806x to parent_data api, I notice
RPM was still using pxo_board clk.

pxo and pxo_board are the same clock and are defined just to handle old
clock definition. It was discovered that rpm is the last driver using
pxo_board instead of pxo.

While updating the rpm driver I notice the documentation was also wrong,
so this series also fix that.

Christian Marangi (5):
  dt-bindings: clock: fix wrong clock documentation for qcom,rpmcc
  ARM: DTS: qcom: fix dtbs_check warning with new rpmcc clocks
  clk: qcom: clk-rpm: convert to parent_data API
  ARM: dts: qcom: add pxo/cxo clock-output-names for ipq8064
  clk: qcom: gcc-ipq806x: remove cc_register_board for pxo and cxo

 .../devicetree/bindings/clock/qcom,rpmcc.yaml | 77 ++++++++++++++++++-
 arch/arm/boot/dts/qcom-apq8064.dtsi           |  2 +
 arch/arm/boot/dts/qcom-ipq8064.dtsi           |  4 +
 arch/arm/boot/dts/qcom-msm8660.dtsi           |  4 +-
 drivers/clk/qcom/clk-rpm.c                    | 24 ++++--
 drivers/clk/qcom/gcc-ipq806x.c                |  8 --
 6 files changed, 98 insertions(+), 21 deletions(-)

-- 
2.36.1




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux