Re: [PATCH v9 1/3] phy: qcom-edp: add regulator_set_load to edp phy

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Quoting Kuogee Hsieh (2022-05-20 13:06:05)
> This patch add regulator_set_load() before enable regulator at
> eDP phy driver.
>
> Signed-off-by: Kuogee Hsieh <quic_khsieh@xxxxxxxxxxx>
> ---
>  drivers/phy/qualcomm/phy-qcom-edp.c | 3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
> index cacd32f..0b7f318 100644
> --- a/drivers/phy/qualcomm/phy-qcom-edp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-edp.c
> @@ -639,6 +639,9 @@ static int qcom_edp_phy_probe(struct platform_device *pdev)
>         if (ret)
>                 return ret;
>
> +       regulator_set_load(edp->supplies[0].consumer, 21800); /* 1.2 V vdda-phy */
> +       regulator_set_load(edp->supplies[1].consumer, 36000); /* 0.9 V vdda-pll */

Why aren't there checks for errors on these API calls?



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux