On Wed 09 Mar 13:01 CST 2022, Ansuel Smith wrote:
> Add missing definition for mdio0 pins used for gpio-bitbang driver,i2c4
> pins and rgmii2 pins for ipq8064.
>
I'm probably not looking hard enough, but I don't see where these are
used. Could they be introduced as they are being wired into their client
devices?
Thanks,
Bjorn
> Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
> Tested-by: Jonathan McDowell <noodles@xxxxxxxx>
> ---
> arch/arm/boot/dts/qcom-ipq8064.dtsi | 34 +++++++++++++++++++++++++++++
> 1 file changed, 34 insertions(+)
>
> diff --git a/arch/arm/boot/dts/qcom-ipq8064.dtsi b/arch/arm/boot/dts/qcom-ipq8064.dtsi
> index 11481313bdb6..cc6ca9013ab1 100644
> --- a/arch/arm/boot/dts/qcom-ipq8064.dtsi
> +++ b/arch/arm/boot/dts/qcom-ipq8064.dtsi
> @@ -382,6 +382,15 @@ mux {
> };
> };
>
> + i2c4_pins: i2c4_pinmux {
> + mux {
> + pins = "gpio12", "gpio13";
> + function = "gsbi4";
> + drive-strength = <12>;
> + bias-disable;
> + };
> + };
> +
> spi_pins: spi_pins {
> mux {
> pins = "gpio18", "gpio19", "gpio21";
> @@ -424,6 +433,8 @@ mux {
>
> pullups {
> pins = "gpio39";
> + function = "nand";
> + drive-strength = <10>;
> bias-pull-up;
> };
>
> @@ -431,9 +442,32 @@ hold {
> pins = "gpio40", "gpio41", "gpio42",
> "gpio43", "gpio44", "gpio45",
> "gpio46", "gpio47";
> + function = "nand";
> + drive-strength = <10>;
> bias-bus-hold;
> };
> };
> +
> + mdio0_pins: mdio0_pins {
> + mux {
> + pins = "gpio0", "gpio1";
> + function = "mdio";
> + drive-strength = <8>;
> + bias-disable;
> + };
> + };
> +
> + rgmii2_pins: rgmii2_pins {
> + mux {
> + pins = "gpio27", "gpio28", "gpio29",
> + "gpio30", "gpio31", "gpio32",
> + "gpio51", "gpio52", "gpio59",
> + "gpio60", "gpio61", "gpio62";
> + function = "rgmii2";
> + drive-strength = <8>;
> + bias-disable;
> + };
> + };
> };
>
> intc: interrupt-controller@2000000 {
> --
> 2.34.1
>
