From: Ulf Hansson <ulf.hansson@xxxxxxxxxx> For the ux500v2 variant of the PL18x block, any block sizes are supported. This will make it possible to decrease data overhead for SDIO transfers. This patch is based on Ulf Hansson patch http://www.spinics.net/lists/linux-mmc/msg12160.html Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx> enabled this support on qcom variant. Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx> Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> --- drivers/mmc/host/mmci.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index c11cb05..3089fba 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -77,6 +77,7 @@ static unsigned int fmax = 515633; * @qcom_fifo: enables qcom specific fifo pio read logic. * @reversed_irq_handling: handle data irq before cmd irq. * @qcom_dml: enables qcom specific dma glue for dma transfers. + * @any_blksize: true if block any sizes are supported */ struct variant_data { unsigned int clkreg; @@ -102,6 +103,7 @@ struct variant_data { bool qcom_fifo; bool reversed_irq_handling; bool qcom_dml; + bool any_blksize; }; static struct variant_data variant_arm = { @@ -194,6 +196,7 @@ static struct variant_data variant_ux500v2 = { .pwrreg_clkgate = true, .busy_detect = true, .pwrreg_nopower = true, + .any_blksize = true, }; static struct variant_data variant_qcom = { @@ -212,6 +215,7 @@ static struct variant_data variant_qcom = { .explicit_mclk_control = true, .qcom_fifo = true, .qcom_dml = true, + .any_blksize = true, }; static int mmci_card_busy(struct mmc_host *mmc) @@ -239,10 +243,11 @@ static int mmci_card_busy(struct mmc_host *mmc) static int mmci_validate_data(struct mmci_host *host, struct mmc_data *data) { + struct variant_data *variant = host->variant; + if (!data) return 0; - - if (!is_power_of_2(data->blksz)) { + if (!is_power_of_2(data->blksz) && !variant->any_blksize) { dev_err(mmc_dev(host->mmc), "unsupported block size (%d bytes)\n", data->blksz); return -EINVAL; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html